Coir roll matting – Coir mats, sometimes called an erosion control carpet, are made from coir fibers spun into yarn and then woven together. The resulting spaces between the fabric are large enough to allow sunlight to penetrate the seeds or seedlings, which promotes vegetation growth but also helps suppress weed growth and control erosion.
Where to Use Coconut Coir Roll Matting
Erosion removes important nutrients from the topsoil that are necessary for successful vegetation growth. It also interferes with the plant’s root establishment.
A common place to install erosion carpets is in areas where vegetation has difficulty taking hold due to erosion. This may include areas of high water and restoration of wetlands or coastlines. Coco mats are also often used for erosion control on hillsides. Other areas prone to erosion include dry areas, such as the desert, where strong winds move dry soil and sand from one place to another.
In wet areas, erosion leaves traces in the soil, visible plant roots and visible runoff paths where mud has gone down slopes, destroying vegetation and soil stability over time. In severe cases, it can create landslides and threaten homes.
Erosion Control for Hillsides
There are always concerns about potential erosion when it comes to slopes and/or slopes. Every time it rains, the soil loosens and forms particles. As these particles collect and move down the slope, other particles will be picked up along the way. Do the math and you’ll discover how a rainstorm can cause massive erosion if left unchecked. Every particle that falls into the water will settle as the runoff slows. These areas will in turn have an accumulation of sediments and will generate serious problems for the stability of certain areas, such as swimming pools or vehicle entrances.
Coir geotextiles Erosion Control Matts These situations can cause blockages in neighborhood drainage and storm drain systems. Erosion has always been a major problem for homes located around hillsides because the lots have cut slopes at the top and fill slopes at the bottom.
Different slopes have different requirements for erosion control. Cut slopes have a greater risk of surface erosion problems. Fill slopes may experience surface erosion, but are more likely to cause subsoil problems as a result of inadequate compaction prior to construction.
How to Install Erosion Control Coir Roll Matting
The success of an erosion mat depends in part on proper installation. Dig a trench 6 to 8 inches deep near the top of the mat and nail the mat into the trench with wooden stakes or staples, depending on soil conditions. For environmentally friendly erosion prevention, use 100% biodegradable wooden sticks or staples, such as those made from cornstarch. If they are not available, finally remove the pins or staples.
Once the mat is secure, fill the trench with soil and fold the excess mat on top over the soil. This method will prevent water from being trapped under the erosion layer and will help you succeed in preventing erosion. Roll out the mat so it is flat against the ground and dig another trench to install it in the same way near the bottom of the mat. Compact the soil fill over each trench.
On the surface of the ground, drive nails or staples securely into the coir mat 15 to 23 inches along the length of the mat and deep enough that they are flush with the surface of the ground. Be sure to leave a 6- to 8-inch overlap of side-by-side erosion plates, and secure a series of staples with approx. 12 inch spacing along adjacent boards.
After placing the coir mat in areas prone to erosion, look for tears or holes and replace those parts for maximum erosion prevention.
Maybe you like to read the following article Woven Coir Geotextiles Uses to Prevent Soil Erosion in Critical Areas
